To Make a Cigarette Dispenser, you have to cut two 5 x 7-inch rectangles out of the plywood. You need to Place one of these 5 x 7-inch pieces on a flat surface so that the long sides are facing away from you. After that, make a 1 x 4-inch cutout on the very bottom of this piece. You must Center the cutout in between the two long sides. You have to end up with a sort of notch on the bottom of this piece that is 1 inch high and 4 inches wide.
Then, Cut two 2 x 7-inch strips out of the plywood. You should cut a 4 x 5-inch square out of the plywood. Next, join together the two 5 x 7-inch pieces and the two 2 x 7-inch strips in the form of a box. You can Glue them all in place and let the glue dry thoroughly. Forth, cut a 3 x 5-inch strip out of the plywood. After the glue on the cigarette dispenser has dried, you need to drop this strip in from the top of the box.
You must adjust the strip so that the strip is angled down toward the notch at the bottom of the front of the dispenser. After that, Remove the strip and place glue along its edges. You should Place the strip back in the dispenser exactly as before and allow the glue to set in place. Then, Place the dispenser on top of the 4 x 5-inch square. You can Glue the dispenser to the 4 x 5-inch base. Next, Cut 2 very thin strips, 1 x 2 inches, out of the plywood.
You have to cut another strip, 1 x 5 inches. You need to Glue the very thin strips to the sides of the dispenser base and the larger strip to the front of the base. You must have what looks like a tiny tray in front of your cigarette dispenser.