To Make a Sun Prism, you have to select six glass bevel triangles from the bevel pack. You need to lay them out side-by-side to ensure they are the same size. After that, Score a horizontal line 1/8 inches from the tip of a bevel’s corner and crack off the tip by hand. You need to Do this to three of the bevels so that you can insert the metal chain near the end of constructing the prism. Then, Wrap foil around the outside edges of each triangle bevel.
You must spread clear silicone along the interior edge of each section of foil before joining the three bevels with tape to avoid leakage. You should Tape the three bevels together with the 1/8-inch shortened tips pointing upward. You can Rest the temporarily taped piece on a flat surface. You have to meld the soldering iron wire into the copper-wrapped seams with the solder gun. You need to work from top to bottom to seal the seams.
Next, solder a small chunk of soldering iron onto one end of the chain. You must pull the un-soldered end of the chain through the 1/8-inch opening you cut at the top of the prism so that the chunk stops the chain from pulling any farther. Forth, Wrap the edges of the last three bevels. You should tape them together in the same three-sided pyramid fashion and solder them to each other. After that, Position the two sections base to base.
You can rotate until you find the orientation with the smaller seams. You have to Place a piece of solder wire into the gap that prevents any solder material from dripping into the prism. You need to solder the section together. You must rotate to the next side and repeat. Then, Fill the 60cc syringe with distilled water.
You should Slide the needle of the syringe into the top of the prism, next to the chain and squeeze distilled water into the prism so that it is full.