To Make a Wooden Pipe for Smoking Tobacco, you have to Invest in a briar pipe kit that are available in several shapes and styles from many tobacco pipe dealers and pipe makers. After that, trace the pattern of the pipe you want on the side of the briar block. When you have a good idea of your pipe shape, you must slowly start sanding away unwanted briar with your Dremel tool using the tool’s various sanding discs and stones. Then, Pay attention to the evenness and thickness of your pipe walls. Next, continue shaping your pipe with the Dremel tool until you have it about eighty percent shaped.
Once you are about ninety percent done, you should move to the 500-grit sandpaper and continue fine tuning. You can save the last five percent of work for the very fine 800-grit sandpaper that will give your pipe a smooth and silky look. At this point, you have to stain your pipe with an alcohol-based stain. Forth, apply a thin coat of Carnauba wax. Using your Dremel tool at its lowest speed, you need to apply some Carnauba wax to a polishing wheel and polish your pipe.
You must be very careful with this step and be thorough. You should polish your pipe stem, but does not polish inside your pipe bowl. Last, find some tasty tobacco and go smoke your pipe.